GE Industrial Solutions H2007001 G11 Series - Manual (Page 8)

Infinity D Power System Installation Guide: +24V Systems H2007001
Issue 2.0, June 4, 2009 8
Battery Connection Module
Batteries power the load equipment when ac input to the rectifiers is lost. The batteries
are connected to the Battery Connection Module at the top of the frame. An optional Low
Voltage Battery Disconnect (LVBD) contactor provides deep discharge protection if
desired. The System Shunt also resides in the Battery Connection Module.
Rectifier System Module
On the left side of each Rectifier System Module ac is supplied to front accessible
terminal blocks that feed each of the 4 rectifier positions.
The rectifier positions are labeled 1 through 4 from the bottom to the top. At product
introduction, all NE rectifiers operate from 208 to 240VAC nominal.
The DC Distribution provides 10 bullet circuit breaker positions per Rectifier System
module, with room to optionally add 10 more.
Pulsar Controller
The Pulsar system controller monitors and controls system operation. It is required for all
remote telemetry, dry contact alarm closures and precise control of battery voltage.
Converter System Module
The converter positions are labeled 1 through 4 from the bottom to the top. Converters for
this plant are available to convert from +24V to -48V.
The DC Distribution provides 10 bullet circuit breaker positions per Converter System
module. An alternative distribution will add 10 more for a total of 20.
Frame
By simply changing the door, this system can be configured to work with frame sizes of
19”, 23”, and 26” frameworks. Preconfigured part numbers for modules that fit into each
framework are available in the sizes common for most applications. Growth is achieved
by adding one of these supplementary modules. Installation instructions ship with each
module.
Frame Size 19” 23” 26”
+24V Rectifier System Module H2007001
G010E or F H2007001
G010C or D H2007001
G010A or B
+24 to -48V Converter System Module H2007001
G030E H2007001
G030C H2007001
G030A