GE Industrial Solutions H2007001 G11 Series - Manual (Page 68)

Infinity D Power System Installation Guide: +24V Systems H2007001
Issue 2.0, June 4, 2009 68
Restore the LAN Connection to Client Mode
As good policy, always leave the controller in Client mode.
Step Action
1. Press Menu or Accept key,
■
.
2. Press down arrow, ▼, to Configuration.
3. Press the right arrow key, ► (or square “accept” key,
■
) to advance.
4. Press down arrow, ▼, to Communications Ports.
5. Press the right arrow key, ► (or square “accept” key,
■
) to advance.
6. Press down arrow, ▼, to Network Settings.
7. P Press the right arrow key, ► (or square “accept” key,
■
) to advance.
8. Press down arrow, ▼, to highlight DHCP.
9. Press the right arrow key, ► (or square “accept” key,
■
) to advance.
10.
Press down arrow, ▼, to toggle to CLIENT.
11. Press save,
■
.
12.
Press the Back Arrow, §, to return to the default screen.
13.
Wait 2 minutes.
14. Activate changes by removing the latching PWR connection, located on the lower right of the
controller, until the LEDs extinguish.
15. Reapply power by reinserting the PWR connection until latched.
16. Verify Client Mode by pressing Menu>Configuration>Communications Ports>Network
Settings> to show Client mode.