Extron Electronics System 5 IP Series User Guide - Manual (Page 102)

Special Applications, cont’d
System 5 IP Switchers • Special Applications 6-8
15. In the IP Link tab area, click on the address of one half of the IRCM-DV+
module. A configuration page for that part (DVD or VCR) of the module
appears in the area to the right of the IP Link view.
16. Click the Auto Fill Control Module/System Remote button. An Auto Fill
IRCM-DV+ Control Module window appears.
17. As shown in the example below, select the DVD-VCR player and the
corresponding control output port, then click the OK button.
18. In the IP Link tab area, click on the address of the other half of the
IRCM-DV+, and perform steps 16 and 17 to assign commands to that part of
the control module.
19. Complete the rest of the switcher configuration as described in the System 5 IP
Setup Guide: adjust audio and video settings, configure all control ports for IR
or RS-232 communication and select device drivers, configure the rest of the
buttons (including buttons on other control modules), configure e-mail
settings and set scheduling as appropriate.
20. Save (File —> Save) the GC configuration project.
21. To build the configuration and upload it to the switcher, click the Build menu,
then select one of the build options
,
and click the Begin button when the Upload Manager window appears.