Extron Electronics System 5 IP Series User Guide - Manual (Page 73)

5-17 System 5 IP • SIS ™ Programming and Control
PRELIMINAR
Y
Command/r
esponse table for SIS commands (continued)
Command
ASCII
(T
elnet)
URL Encoded (W
eb)
Response
Additional description
(host to switcher)
(host to switcher)
(switcher to host)
Firmwar
e version, part number & information r
equests
Query firmwar
e version number
Q
or
1Q
Q
or
1Q
X1
1
Show the switcher
’s firmwar
e version (
X1
1
)
to two decimal places. This query yields the number of the curr
ently running version of
the user
-updatable firmwar
e.
Example:
1Q
1Q
1.01
Query verbose version information
0Q
0Q
{r
esponse fr
om 2Q}–{r
esponse fr
om 3Q}–{r
esponse fr
om 4Q}
Show the bootstrap, factory-installed, and updated firmwar
e versions. See 2Q, 3Q, and
4Q below
.
Example:
0Q
0Q
0.04-1.00(0.32-System5IP
-W
ed, 16 Jan 2003 01:54:56 GMT)-1.01*(0.32-System5
IP -Mon, 15 Dec 2003 20:22:43 GMT)
Query bootstrap firmwar
e version
2Q
2Q
X1
1
The bootstrap firmwar
e is not user
-
replaceable, but you may need this information during tr
oubleshooting.
Example:
2Q
2Q
0.04
Query factory firmwar
e version
3Q
3Q
X1
1
(kernel version–model description–
date time of upload)
Factory-installed firmwar
e is not user
-
replaceable. This firmwar
e was installed at
the factory; it is the version to which the switcher r
everts after a mode 1 r
eset (see
ch. 2).
Example:
3Q
3Q
1.00(0.31-System5IP
-W
ed, 16 Jan 2003 01:54:56 GMT)
In this example the factory firmwar
e version
is 1.00, a.k.a. kernel version 0.31, for the System 5 IP
, dated 16 January 2003.
Query updated firmwar
e version
4Q
4Q
X1
1
(kernel version–model
description–
date
time
)
Use this command to find out which version of the firmwar
e, if any was uploaded into
the switcher after it left the factory
.
Example:
4Q
4Q
1.01*(0.32-System5IP -Mon, 15 Dec 2003 20:22:43 GMT)
In this example the curr
ent firmwar
e version
is 1.01, a.k.a. kernel version 0.32, for the System 5 IP
, dated
15 December
, 2003.
In a query r
esponse, an asterisk (
*) after the version number indicates the version that is curr
ently used.
A
question mark (
? or
?.??
) indicates that the factory default firmwar
e is the only firmwar
e loaded in the switcher
.
A
carat (
^
) indicates the version of firmwar
e that should be running, but, since a mode 1 r
eset was performed, the factory default firmwa
re version is loaded and running instead.
An exclamation point (
!) indicates that the firmwar
e is corrupted.