Extron Electronics System 5 IP Series User Guide - Manual (Page 12)

System 5 IP Switchers • Installation: Labeling, Mounting, Cabling 2-2
Installation: Labeling, Mounting, Cabling
PRELIMINAR
Y
Pry the button
from the base.
UL/Safety Requirements
The Underwriters Laboratories (UL) requirements listed below pertain to the safe
installation and operation of a System 5 IP Switcher.
1. Do not use the switcher near water or expose it to liquids.
To reduce the risk of fire or electric shock, do not expose this apparatus
to rain or moisture.
2. Clean the switcher only with a dry cloth.
3. Do not install the switcher near any heat source, such as a radiator, heat
register, stove, or another apparatus (including amplifiers) that produces
heat.
4. Unplug the switcher during lightning and thunder storms or when it will
be unused for long periods.
Installing or Replacing Button Labels
For the System 5 IP with front panel buttons or an optional SCP control panel,
you may wish to customize the button labels. The labels can
be changed at any time, but it is more convenient to change
them before you rack mount the switcher. Follow these steps
to change the translucent button labels:
1. Remove the button assembly from the switcher.
The button assembly consistes of a clear lens
cap, the label, and a white diffuser. See the
exploded view diagram below.
Insert a small, flat bladed screwdriver, such as
an Extron Tweeker, to gently pry a button
assembly off from button plunger, as shown at
right.
TEXT
Separating the two-
piece button here at
the corner.
Pry the two
pieces apart.
Diffuser
Plunger
Base
Button Label
Clear Lens
Notch
2. Locate the small, corner notch on the lens cap and slide the screwdriver
between the lens cap and the diffuser. See
A
in the picture below.
3. Using a rotating motion of the screwdriver
(see
B at right), carefully pry the two
pieces apart.
4. Select a button label from the
printed label sheets
included with the
switcher. Remove
the label from its
backing, if
applicable, and
insert the button
label into the
button cap.
5. Press the lens cap
and diffuser back
together, and reverse steps
2 and 1 to reinstall the button
in the switcher’s front panel.
6. Repeat steps 1 to 5 as needed to relabel other buttons.
A
B