Extron Electronics System 5 IP Series User Guide - Manual (Page 67)

5-11 System 5 IP • SIS ™ Programming and Control
PRELIMINAR
Y
V
iew Clip (Max) status
3S
3S
X5
Clipping level: 0 = of
f (Audio input is set up pr
operly
.)
1 = on. (The level or gain is too high, audio clips/distorts. Output equipment could be damaged.
Adjust the switcher
’s input level
so only the Mid/Normal LED is blinking. The Max/Clip LED should not turn on.)
Additional status commands
V
iew lamp hours status
6S
6S
X205
or
X205
*
X205
X205
r
epr
esents the number of elapsed hours
of pr
ojector lamp use.
The switcher r
esponds with one number unless it has been set up to monitor and r
eport two sets of lamp hours.
Set lamp hours status for 1 lamp
24
X205
*6S
X205
%2A 6S
Lhr
*
X205
X205
r
epr
esents the five-digit numeric value
for elapsed lamp use hours, and it is used by script as a starting point to determine the number sent in r
esponse to the “view lamp
hours” command (6S, above).
Set lamp hours status for 2 lamps
24
X205
*
X205
*6S
X205
%2A
X205
%2A 6S
Lhr
*
X205
*
X205
V
iew max. lamp hour status
10S
10S
X205
X205
r
epr
esents the maximum number of
hours of pr
ojector lamp use to allow befor
e
changing the lamp. The switcher can be configur
ed to send an email alert when the
lamp has been used for this number of hours.
Set maximum lamp hours
X205
*10S
X205
%2A 10S
LhrMax*
X205
Set maximum allowed pr
ojector lamp hours.
V
iew connection status
7S
7S
X216
This command lets you know whether or not the switcher
’s scripts have determined
(based on power polling) if the display is still connected to the switcher
.
X216
=
0 = pr
ojector not connected.
1 = pr
ojector is connected.
2 = undetermined status.
Set connection status
24
X216
*7S
X216
%2A 7S
Pcs
X216
This command is used to r
eset the pr
ojector
connection status flag (
X216
) used by scripts.
Command/r
esponse table for SIS commands (continued)
Command
ASCII
(T
elnet)
URL Encoded (W
eb)
Response
Additional description
(host to switcher)
(host to switcher)
(switcher to host)