Burkert Type 8619 - Manual (Page 49)

47
Adjustmentandcommissioning
This is
when the
device is be-
ing parame-
tered............
.................... This is
when the
device is be-
ing parame-
tered............
....................
Type:
Name:
Status:
ENTERING
ON
OFF
PV:
1)
M1:
M0:MAIN
Mx:
...
PV range: PVScale-:
PVScale+: ENTERING
ENTERING
Lim-
Lim+: ENTERING
ENTERING
CMDSafe: Mode
Value
ON
OFF
ENTERING
PV filter: None
Fast
Slow
PROP Parameters Functions F1...F6:
1) The choices offered depend on the modules fitted and/or the options activated. See chap. 8.10.4 and chap. 8.16.
Once the function has been configured and activated, the result "Fx:" calculated is available in the list of
process variables on the "M0:MAIN" board. This list appears in the output configuring, user view config-
uring and datalogging menus to:
• Assign the result "Fx:" calculated to a physical output (analogue, AO, or digital, DO) (see chap. 8.10.22
and 8.10.22).
• Display the result "Fx:" on one of the user defined "Ux" views: see chap. 8.10.8.
• Logging the values of "Fx:" using the datalogger: see chap. 8.10.18.
TYPE: Indicates the function chosen (here, "PROP").
NAME: Rename the function chosen. See chap. 8.4. This name appears on the view associated with this function
in Process level.
STATUS: Used to activate (choose "ON") or deactivate (choose "OFF") the function selected.
PV: Choose the process input for the function.
PV RANGE: Enter the minimum ("PVScale-" ) and maximum ("PVScale+") values of the process input.
PV FILTER: Choose the level of damping of the chosen process value. See Figure 29.
LIM-: Enter the lower limit on the output.
LIM+: Enter the upper limit on the output.
Type 8619
english