Burkert Type 8619 - Manual (Page 60)

58
Adjustmentandcommissioning
.
.
.
Parameters Functions F1...F6: PID
Setup
This is
when the
device is be-
ing parame-
tered............
.................... This is
when the
device is be-
ing parame-
tered............
....................
CutOff: Mode:
Cut-:
Cut+:
Cut-
OFF
Cut-Cut+
Cut+
ENTERING
ENTERING
SPlimit: Mode:
SPlimits-
SPlimits+:
ON
OFF
ENTERING
ENTERING
Inversion ON
OFF
CMD Safe: Mode:
Channel 1/2:
ON
OFF
ENTERING
Advanced
Channel 1/2:
SPLIMIT: Set the low and high limits of the setpoint value in order to limit the working range of the setpoint.
CUTOFF: Force or do not force the module output to 0% or 100% if the setpoint value is outside a range defined
by "Cut-" and "Cut+", or under the low range "Cut-", or above the high range "Cut+".
100
99
98
97
96
5
4
3
2
1
100
99
98
97
96
5
4
3
2
1
Cut-
Cut+
Cut-
Cut+
setpoint ("SP") setpoint ("SP")
Fx: (CMD) (%) Fx: (CMD) (%)
Figure 47 : "CUTOFF" graphs
CMD SAFE: Confirm (choose "Mode: ON") or do not confirm (choose "Mode:OFF") the use of a fallback position
on the output when the "System switch" event (see chap. "8.10.17. Configuring the "System switch" event") has
the state "ON". When use of the fallback position is confirmed, enter a fallback position value of between 0 and
100% for each output.
Type 8619
english