Burkert Type 8793 - Manual (Page 46)

46
Packaging, Transport, Storage
Type 8792, 8793
16.3.2 Manually changing the process set-
point value
Vorgehensweise:
1. Set the internal preselected set-point value on the setting level:
In the main menu (MAIN) select the P.CONTROL function
P.CONTROL ENTER SETUP ENTER SP-INPUT intern
SELEC
→
Return to the process level via the EXIT button (press 4 x).
2. Manually change the process set-point value on the process
level:
→
Using the arrow keys , select the
display for the process set-point value
(SP).
MENU PV PV (t) INPUT
SP 30.0
m3/min
→
Press the INPUT button..
→
Input
process
set-point
value (as
described
in the image
on the right).
ESC + <- OK
SET VALUE
SP:
[m3/min]
70.0
+
070. 0
Accept set value
Return
without
change Change by one place to the left
Increase number
Changeable number
Inputting values:
Fig. 27: Inputting values
17 PACKAGING, TRANSPORT,
STORAGE
NOTE!
Transport damages!
Inadequately protected equipment may be damaged during
transport.
• During transportation protect the device against wet and dirt in
shock-resistant packaging.
• Avoid exceeding or dropping below the allowable storage
temperature.
Incorrect storage may damage the device.
• Store the device in a dry and dust-free location!
• Storage temperature. -20 – +65 °C.
18 DISPOSAL
→
Dispose of the device and packaging in an environmentall
friendly manner.
NOTE!
Damage to the environment caused by device components
contaminated with media.
▶ Observe applicable regulations on disposal and the environment.
Note:
Observe national waste disposal regulations.
english