CTI Products RCD Standard - Remote Comparator Display - Manual (Page 19)

MCN Remote Comparator Display Configuring a System
CTI Products, Inc. Using MCNCFG
68-10856-210
13
2. Build a MCN Screen File (SCF):
a) Use the Files New Screen menu command to open a new MCN
Screen File.
b) The Active Group Files dialog box will appear. Press E to pop up a
list of GCF files. Select the GCF file(s) that you want to display on the
screen. Tab to <OK> and press
E .
c) The Select Active Group File dialog box will be displayed. Select
the Group Configuration File you wish to work with first.
d) Enter Channel Titles using the Insert key.
e) Place receivers on the screen using the E key and selecting from the
receiver list.
f) If your MCN HIB module has a model number S2-60081-xxx where
‘xxx’ is the number 200 or greater (this number is found on the rear of
the module), set the GROUP and MODULE rotary switches to the unit
address you defined for the HIB (these switches are found on the rear
of the module. Skip to step h.
g) If your MCN HIB module has a unit number where ‘xxx’ is less than
200 or if you are using a PCLTA card, you must execute the Edit HIB
Address command to specify the MCN address of the HIB module or
PCLTA card that will be connected to this PC.
Program the Group and Module numbers that you defined for the HIB.
h) Use the Edit Screen Name menu command to add a screen name.
i) If you use a dial-up modem, use the Edit Dialing String menu
command to enter a dialing string (the phone number of the remote
HIB).
j) Use the Files Save menu command to save the MSF file.
The remainder of this section will walk you through the above steps. There are
some additional menu commands that will be covered later.
6.2 Starting the MCNCFG configuration program
1. Exit any application software you are running.
2. Change the current directory to C:\CTI
3. Type: MCNCFG E
This will Start the MCNCFG configuration program and display a screen similar
to the one in Figure 3, but with just the menu bar.
6.3 Using the MCNCFG Menu Commands
The MCNCFG program commands are accessed through the programs pull-down
menus. These function similarly to the pull-down menus in many popular DOS
and Windows

programs.
The Menu Bar is the top line of the screen. The Menu Bar is always visible. Each
item on the bar is the name of a pull-down menu. Press the
H key to activate the
Menu Bar. The File Menu Name is now selected.