CTI Products RCD Standard - Remote Comparator Display - Manual (Page 33)

MCN Remote Comparator Display Configuring a System
CTI Products, Inc. Using MCNCFG
68-10856-210
27
6.5.2 Specify Group Configurations Dialog Box
When you build a screen, you must select the Group Configuration File(s) that
contain the receivers you want to monitor and control. Up to four different MCN
Groups can be monitored and controlled in a single MCN Screen File.
To Select Group Configuration Files:
1.
The cursor will start in Group File 1.
2. Press the E key or left-click the mouse in the Group File 1 box. A list of
Group Configuration Files will appear.
3. Select the Group Configuration File for the Group that this screen will
monitor. Double click on your choice or press E .
Note: Repeat this procedure if you want to monitor and control receivers from
more than one MCN Group.
4. Press the T key until the <OK> button is highlighted and press E . (You can
also use the mouse to click the < OK > button.)
Figure 14 - Selecting a Group Configuration File
Normally the Active Group Files dialog box is used only when you start to build
a new MCN Screen File. You can also bring up the Active Group Files dialog
box using the Edit Group Configurations menu command to change the GCF
files that a screen refers to. If you change a Group File name using the Edit
Group Configurations menu command, any receivers names from the original
Group Configuration File that were placed on the screen will be changed to the
receiver names from the new Group Configuration File. When you press the
<OK> button, the MCNCFG program will bring up the Set Active Group File
Dialog box.