Luminex 100 IS Version 2.1 - Manual (Page 19)

x MAP Technology Luminex xMAP Technology
PN 89-00002-00-062 Rev. A 13
Bead Set tab. The default value is 1000. The recommended
minimum is 100 per bead set.
• By selecting Per Bead the system will continue to analyze
until each bead set has met the events as determined on the
Bead Set tab.
• By selecting Total Beads the system will continue to analyze
until the total bead event measurement is met.
11. Click the Plate Layout tab. The Options Plate Layout tab dialog
appears. On this tab you define commands for the desired wells
on a plate.
Figure 4. New Advanced Batch—Plate Layout Tab
12. To select a single well click the well. To select multiple wells in
a group, click and hold the mouse button over the first well then
drag the box around the desired wells.
13. Right-click over the selected wells to display the popup
command menu. The menu appears. Select the desired command
to apply the command symbol to the designated plate well. To
make a correction, select the wells (selected wells are blue), then
right-click over the selected wells and then select Clear Selection
from the list.
Legend shows available
commands and their color coded
symbols. Symbol appears in the
well when selected from
Command Menu.
Table 3: Symbol Color
Codes
Symbol Color
A
C1
C2
N1
N2
W
D
Blue
Red
Green
Teal
Purple
Olive
Black
Note: Wells are always read in
rows (letters A to H) and columns
(numbers 1 to 12) starting with A1.
If partial columns are selected they
are still read in the same order.
Unselected wells are skipped.
Note: Preliminary Off-Plate
commands are performed before
the first selected well on the plate
and are indicated by a green
square in the top left corner of the
plate. An Insert Off-Plate
command is performed after the
selected well and is indicated by a
green background behind the well.