Luminex 100 IS Version 2.1 - Manual (Page 32)

Luminex 100 IS Developer Guide to xMAP Technology Version 2.1 x MAP Technology
26 PN 89-00002-00-062 Rev. A
The Apply Unit button applies the same unit value entered on
the first line to all other tests. For example, if mg/uL is entered
for the first Test Unit, then select the Apply Unit button to make
all tests mg/uL.
7. Enter the Number of Standards for this product and press Enter
key.
8. Enter the Reagent Name for each standard in this product. Each
standard reagent must test for every analyte (bead set) used in the
assay. See example in Figure 15.
9. After entering all the information, check it carefully. When all
the information is correct, click Save to save the product.
10. Click Close.
Assay Controls
‹ To create a product that consists of assay controls:
1. Click the Create New Product button on the toolbar. The Create
New Product dialog box appears listing the existing products.
2. Click New to enter a new product into the system. You do not
need to press the New button for the first use.
Note: If the reagent names are
similar, click the Apply Suffix
button to ensure that each
name is unique.