Luminex 100 IS Version 2.1 - Manual (Page 46)

Luminex 100 IS Developer Guide to xMAP Technology Version 2.1 x MAP Technology
40 PN 89-00002-00-062 Rev. A
Figure 24. Open Reagent Product
9. Highlight the product to add to the template. The test and reagent
information appears for the product highlighted to help you make
your selection. You can not edit the information here.
10. Select the product that you want to add to the template and click
Open.
11. The system applies the standard and/or controls in the product to
the template. Edit the Test Name and Test Units on the following
Template Setup Wizard dialog box if needed. The changes you
make are effective for this template only, changes are not made
to the original product.
The Apply Unit button applies the same unit that you entered in
the first line to all other tests.
12. At the Template Setup Wizard dialog, select the Bead ID for
each test listed. Type the bead ID or select it from the drop-down
chart (optionally, select the first bead ID then click the Apply
Bead ID Increment button to auto fill the remaining entries with
sequential bead IDs).
This list shows all saved
products. Select the desired
product from the list
Note: If the desired product is
not present in the list, select
New to create a new product.
Note: You can use the same
products in multiple templates.
Therefore, as you build up a
library of products, making
templates becomes an easier
and faster process.