Luminex 100 IS Version 2.1 - Manual (Page 55)

x MAP Technology Luminex xMAP Technology
PN 89-00002-00-062 Rev. A 49
Figure 34. Selecting Template Commands
5. Select commands from the Available Commands list and move
them to the Template Commands list using the single arrow
pointing towards the template command button.
These commands are then part of the template and are always
performed in the order specified for any batch that uses this
template. Each well command is automatically assigned to the
next available well. Laboratory personnel can select the starting
location on the plate, but can not change these commands.
Remember, if you have more than one command that involves
the reservoir, those commands must use the same solution
6. After all the information has been entered for your template,
check it carefully. When all the information is correct, click Save
to save the template, then click Close to exit.