Luminex 100 IS Version 2.1 - Manual (Page 43)

x MAP Technology Luminex xMAP Technology
PN 89-00002-00-062 Rev. A 37
Qualitative Assay Using
Standards or Controls
‹ To create a template for qualitative tests.
1. Click the Create Template button on the Developer Workbench
toolbar. The Template Setup Wizard dialog box appears:
Calibrate CAL2 Acquires calibration beads from a well to
calibrate the Reporter channel.
Drain to
reservoir Removes and refills sheath fluid from the
cuvette. Sheath fluid is expelled into the
reservoir.
Drain to well Removes and refills sheath fluid from the
cuvette. Sheath fluid is expelled into a well
Prime Primes the system to remove air from the
sheath side of the instrument.
Sanitize Acquires sanitizing solution from the reservoir
to sanitize or eliminate air in the cuvette.
Verify CON 1 Acquire CON 1 beads from a well to verify
that the system is working within the
calibrated settings.
Verify CON 2 Acquire CON 2 beads from a well to verify
that the system is working within the
calibrated settings.
Warmup Checks for proper system warm up and if
needed begins the warmup process.
Wash from
Reservoir Acquires wash solution from reservoir to wash
the system.
Wash from Well Acquires wash solution from a well to wash
the system.
Table 8: Available Commands (Continued)
Command Definition
Note: You must define each
Qualitative template using a
single product. The product
must contain one standard.
The standard is assigned lot
value information for each
test. A control product is
optional.