Luminex 100 IS Version 2.1 - Manual (Page 49)

x MAP Technology Luminex xMAP Technology
PN 89-00002-00-062 Rev. A 43
Figure 27. Selecting Template Commands
16. Select actions from the Available Commands list and move them
to the Template Commands list using the single arrow pointing
towards the template command list.
These commands become part of the template and will always be
performed in the order specified for any batch that uses this
template. Each well command is automatically assigned to the
next available well. Laboratory personnel can select the starting
location on the plate, but cannot change these commands.
Remember, if you have more than one command that involves
the reservoir, those actions must use the same solution.
For a complete list of command descriptions see Table 8,
“Available Commands”
17. After entering all the information for your template, check it
carefully. When all the information is correct, click Save to save
the template, then click Close to exit.
Data Collection Only
You do not need to apply standards or controls when you use a
template for data collection only. If you select standards or controls,
no calculations will be applied to the data. Median results will be
exported to an output file.
Note: You can return and edit
any unused templates using the
Edit Templates feature.