Micromod Micro-PWC: 53PW6000 MicroPWC Configuration Guide - Manual (Page 165)

Micro-PWC CONFIGURATION GUIDE
Grafx Editor 145
4.4 Micro-DCI Submodels
Micro-DCI Submodels are submodels which have been supplied with the Micro-DCI software and contain
pre-configured dynamic attributes. These submodels are used:
• to display dynamic data from the controller database, using various forms such as valves and
bargraphs,
• for the control of controller modules, and for the assignment of display vectoring (i.e., the
ability to call up a specific display directly from another display).
The assignment of controller database points to these dynamics is accomplished through the Submodel
Configuration windows. To access the Submodel Configuration windows, position the pointer on the sub-
model, click the right mouse button, and select Configure Submodel from the resulting pop-up menu.
4.4.1 Dynamic Values
4.4.1.1 FP_DYvalue
The submodel FP_DYvalue ( Figure 4-20 ) is used for the dynamic display of data from a controller data-
base point. It is used for both numeric and ASCII data types.
Figure 4-20. Dynamic Value (FP_DYvalue)
Position the pointer on the submodel and click the right mouse button. Click on the Configure Submodel
item on the resulting pop-up menu, or double-click on the submodel. The Submodel Configuration window
(
Figure 4-21 ) will appear.
Figure 4-21. Dynamic Value Configuration Window
✎ Note
If a dynamic submodel is copied from one child window to another
within the Grafx editor window, the configuration for the submodel is
copied as well.