Micromod Micro-PWC: 53PW6000 MicroPWC Configuration Guide - Manual (Page 58)

Micro-PWC CONFIGURATION GUIDE
38 System Configuration
Micro-PWC, printer output will automatically be directed to the parallel port on that Micro-PWC. If the
selected Node Name is that of a printer server, the port number can be selected. To change this parameter,
click the Port Number button. A window titled Available Ports will be displayed, which contains a list of
available ports for the selected node name. Click on the entry for the port to be used, then click OK to com-
plete the selection process.
2.8.3.1.6 File Size
All messages sent to a device are automatically stored in a file, which can be viewed by choosing Select >
Printer Review from the Operator Window menu bar. If you elect to define a file (instead of a printer) as the
device to which messages are sent, this is the file which is used. In either case, the default file size is 50
lines.
The File Size parameter is used to configure the number of lines to be stored in the file. To change this
parameter, click the File Size button. A window will appear which contains a list of supported sizes;
choices include 50, 100, 500, 1000, 5000, or 10,000 lines. Highlight the desired selection. Click OK to
complete the selection process.
2.8.3.1.7 Use ETX/ACK Protocol
2.8.3.1.8 Emulation
A button labelled Emulation is used to configure this parameter. It is available for use when the Device
Type parameter is set to Line Printer. Click Emulation to toggle between Epson (the default) and IBM Pro-
printer emulation. Choose the emulation supported on your printer.
✎ Note
The Micro-PWC software does not supportd the ETX/ACK protocol.
✎ Note If a Device Type other than Line Printer is selected, this parameter
is stippled out, and the face of the button is blank.