Micromod Micro-PWC: 53PW6000 MicroPWC Configuration Guide - Manual (Page 192)

Micro-PWC CONFIGURATION GUIDE
172 Grafx Editor
4.4.3.7 FP_DYputpbstat
The submodel FP_DYputpbstat ( Figure 4-48 ) is a pushbutton which, when pressed, writes values into up
to 4 controller database points and shows a red status "light" when the value of a controller database
tag.atom is set to a configurable value. The following example shows an instance of FP_DYputpbstat con-
figured to put the CON module tcPID into AUTO mode when the button is "pressed" (clicked on). Addition-
ally, when the AUT atom of the controller is set, the status light appears in red.
Position the pointer on the submodel and click the right mouse button, then click on the Configure Sub-
model item on the resulting pop-up menu. The Submodel Configuration window for the PUTPBSTAT Push-
button Submodel will appear. Notice that this window (
Figure 4-49 ) is scrollable and contains more
variables than those which appear in the display area. Use the scrollbar to access the additional variables
(
Figure 4-50 )
Figure 4-48. Putpbstat Submodel (FP_DYputpbstat)
Figure 4-49. Putpbstat Submodel Configuration Window, Part 1