IAI America IA-T-XD - Manual (Page 29)

Select the F1 (Edit) key on the Mode Selection
screen.
Select the F2 (Prog) key on the Edit mode screen.
Select the F1 (Mdfy) key on the Edit-Prog (program
edit and new creation) screen.
The screen changes to the program No. input mode
screen. The cursor is located at the program No.
Press the return key to move the cursor to the
location of the step No.
* When the program’s data is already input,
overwrite it (the original data is lost) or select the
program No. with no data input. The program No. or
step No. over which the cursor is located can be
changed with the PAGE UP and PAGE DOWN keys.
In addition, pressing the return key after inputting a
numeric value with the ten-key numeric pad can
change the program No. or step No.
Program No.
Step No.
Number of steps stored
in the controller
26