Teledyne LeCroy Merlin - Users Manual - Manual (Page 107)

99
Merlin Protocol Analyzer User’s Manual CATC SW Version 2.0
specified event.
To filter an event in or out of a recording,
Step 1
Click the blue dot on Filter Out. (Note: the button may say
Filter In depending on the last action specified.)
You see the Filter Out/In menu:
Use this menu to toggle the selection between Filter Out and Filter In.
Step 2
Select "Filter In".
The button changes to read "Filter In".
Blue Dot Menus for the Event Buttons
The Errors button and the first Headers button (marked "Hdr1") have the
same Blue Dot menus. These menus allow Merlin to trigger external output.
To enable or disable external trigger output,
Step 1
Click the Blue Dot on an Event button such as Hdr1 or Errors.
A menu similar to the one below will open. Your menu may say
"Disable" instead of "Enable."
Step 2
Select "Enable External Trigger Output" (or "Disable
External Trigger Output" if that is the choice presented.)
If you have chosen "Enable External Trigger
Output", a small arrow will appear on the right side
of the button. This arrow indicates that a condition
has been set for creating an external output signal.
Choosing "Disable External Trigger" will cause the arrow to disappear.