Teledyne LeCroy Merlin - Users Manual - Manual (Page 91)

83
Merlin Protocol Analyzer User’s Manual CATC SW Version 2.0
Debug
Enables the creation of a file that can be used by CATC Support to aid in
debugging.
Configurations List
The Configurations List displays the COM settings for the ports used to
connect the IUT to the host PC.
The Configurations List allows you to manage as list of up to three IUTs to
be recorded and set the parameters for each one. It also allows you to enable
or disable a specific IUT from being recorded. The settings are stored in the
recording options file, like the rest of the recording options.
The Configurations List is made up of the following fields:
• Name - Symbolic name of the IUT given by the user, for easy
identification.
• Controller => Host COM port - The port that is used for the
capturing of the up- link traffic.
• Host => Controller COM port - The port that is used for the
capturing of the down-link traffic.
• Rate - the bits per second rate the COM ports are configured for.
The list displays three possible states for each one of the entries:
• Enabled - The HCI traffic from the IUT is going to be recorded.
• Disabled - The HCI traffic from the IUT is not going to be
recorded.
• Invalid - The analyzer failed in opening the COM port for
accessing the IUT, with the listed parameters. In this case, you
should refer to Windows configuration of the COM ports or check
whether the same COM port(s) is (are) used by other applications in
the host machine or that the parameters are set correctly.