Teledyne LeCroy Merlin - Users Manual - Manual (Page 44)

36
BTTracer Protocol Analyzer User’s Manual CATC SW Version 2.0
Recording Progress
When you begin recording, the left-most segment of the Status Bar displays
a Recording Progress Indicator. The following figure displays the various
indications of the status bar:
Status Bar Position Definitions:
The following numbered definitions correspond to the number labels on the
above status bars.
1 Analyzer is not connected or not configured.
2 Idle mode: Analyzer is connected to the host machine, but is not doing any
attempts to synchronize to a piconet nor record Bluetooth traffic.
3 Analyzer is trying to synchronize to the piconet with the master device that has
BD_Address 00837163787.
4 Analyzer is synchronized to the piconet with the master device that has
BD_Address 00837163787.
5 Analyzer is recording the traffic of the piconet with the master device that has
BD_Address 00837163787. However, no triggering occurred.
6 A trigger event occurred, and the analyzer is recording the traffic of the piconet
with the master device that has BD_Address 00837163787. However, no
triggering occurred.
7 Analyzer is performing a BT Neighborhood action, where it makes inquiries
for Bluetooth devices.
8 Merlin application uploads recorded data from the analyzer at the end of a
recording session.
As recording progresses, the Progress Indicator changes to reflect the
recording progress graphically: