AT&T 585-350-812 - Manual (Page 44)

3-4
ASAI Installation
Installing ASAI Hardware
Prior to installation, you should run the configurator program. For information on
running the configurator program, refer to Chapter 3, “Allocating System
Resources” in the hardware installation and upgrade book for your platform.
Referring to the output from the show_config command and Figure 3-3, set the
Base RAM address selection switches on the IPCI card. Figure 3-2 shows the
location of the Base RAM address location switches. Figure 3-3 shows the various
switch settings for the Base RAM selection switches.
Figure 3-2. IPCI Card
Red LED
Base RAM Address Selection Switches
RAM
HEADSET
PHONE
LINE