AT&T 585-350-812 - Manual (Page 47)

3-7
ASAI Installation
10. Next, the package prompts you for the Interrupt Vector Number (IVN) of the
IPCI card. Refer to the output of the configuration program to determine
what interrupt number to use. Type in the number you have selected and
then press
. If you wish to cancel the software installation process at
this time, you may type q to abort installation.
11. You are now prompted to enter the Memory Address of the card. Refer to
the information under “RAMADDR” from the output of the configuration pro-
gram for this setting for the IPCI card.
12. The UNIX system will now be rebuilt. This takes approximately 2 minutes
to complete.
13. When prompted, remove the disk from the drive.
14. Press to shutdown the system.
15. When prompted, reboot the system. While holding down and
press and release on the numeric keypad, then release
and .
16. Log in to the system as root.
17. Type installpkg at the UNIX system prompt.
18. Insert the floppy disk labeled “CONVERSANT ASAI Package Version 3.1”
and press .
19. Remove the floppy disk when prompted, and load the remaining floppies
into the disk drive when directed to do so. Press .
20. If the Voice System is running, the system asks you whether you wish to
stop the voice system. Type y and then press to stop the voice
system.
21. A message appears stating that the installation of the ASAI package is now
complete.
22. A message appears asking you if you wish to restart the voice system.Type
y and then press if you wish to start the voice system at this
time.Type n if you do not wish to start the voice system at this time (that
is, if you have other software packages to load).
You have now completed loading the ASAI software. Refer to Chapter 4, "ASAI
Administration" to begin work with the various ASAI features and capabilities.
ENTER
ENTER
CONTROL
ALT DELETE
CONTROL ALT
ENTER
ENTER
ENTER
ENTER