Brocade FastIron SX, FCX, and ICX Diagnostic Reference - Manual (Page 169)

Brocade FastIron SX, FCX, and ICX Diagnostic Reference 157
53-1003076-02
PIM debug commands
6
debug ip pim bootstrap
Syntax: [no] debug ip pim bootstrap
This command enables bootstrap debugging and the output resembles the following example.
Brocade# debug ip pim bootstrap
PIM: bootstrap debugging is on
Brocade# PIM-BSR.VRF0: Prefer BSR 10.0.0.43(Pr 43) over current BSR 10.0.0.43(Pr
43)
PIM-BSR.VRF0: Intf tn4 - accept BSM from BSR 10.0.0.43(Pr 43), local state
CandBSR, curr BSR 10.0.0.43 (Pr 43)
debug ip pim clear
Syntax: [no] debug ip pim clear
This command clears all the PIM debug settings. The output will be similar to the following if no
settings are enabled.
Brocade# debug ip pim clear
no debug ip pim is enabled
debug ip pim control-source
Syntax: [no] debug ip pim control-source ipaddr
This command monitors the control packet sent by the given router. The <ipaddr> variable refers to
a particular route.
Brocade# debug ip pim control-source 10.10.10.129
Brocade# IGMP: rcvd Query(t=17) V2 g=0.0.0.0 resp=100, pkt S=10.10.10.129 to
224.0.0.1, on v100 (phy 8/1/22), igmp_size=8
Brocade# IGMP: rcvd Query(t=17) V2 g=0.0.0.0 resp=100, pkt S=10.10.10.129 to
224.0.0.1, on v100 (phy 8/1/22), igmp_size=8
debug ip pim event
Syntax: [no] debug ip pim event
This command enables debugging of PIM events and the output resembles the following example.
Brocade# debug ip pim event
PIM: event debugging is on
Brocade(config)# int ethernet 1/1/11
Brocade(config-if-e1000-1/1/11)# disable
Brocade(config-if-e1000-1/1/11)# Mcastv4 receive event 16
Mcastv4 receive event 16
Mcastv4 receive event 16
Mcastv4 receive event 16
Mcastv4 receive event 13
MC-EVT: Port tn4 state changed to DOWN
PIM-EVT.VRF0: Receive intf tn4 Dn state_notify
Mcastv4 receive event 6
Brocade(config-if-e1000-1/1/11)# enable
Mcastv4 receive event 15
Mcastv4 receive event 15
Mcastv4 receive event 15
Mcastv4 receive event 15