Brocade FastIron SX, FCX, and ICX Diagnostic Reference - Manual (Page 43)

Brocade FastIron SX, FCX, and ICX Diagnostic Reference 31
53-1003076-02
MCT debug commands
3
CCP_PKT(T=105059): Sending Notify message to peer
CCP_PKT(T=105059): Packet
Info:01000016000000120001000e0000015f00000031000000000000
CLUSTER CCP:internal alloc data buf allocated packet count 1 buffer 21a215e8
CLUSTER CCP:alloc data buf allocated packet count 1 buffer 21a215e8
=============== CCP State machine ==============
CLUSTER CCP_FSM(T=105060): Fsm12 10.10.10.2 sending keepalive
CLUSTER CCP PEER(T=105060): Make keep alive message ->
=================== Send Keepalive =======================
CCP_PKT(T=105060): Sending Keep Alive message to peer
CCP_PKT(T=105060): Packet Info:0100000c000000080003000400000160
If the debug cluster ccp command is disabled, the output similar to the following is displayed.
Brocade# no debug cluster ccp
CCP debugging is off for all
debug cluster client-auto-detect
Syntax: [no] debug cluster client-auto-detect
This command displays debugging information related to cluster client auto detect functionality, as
shown in the following example.
Brocade# debug cluster client-auto-detect
CLUSTER AUTOCONFIG INFO - New Client: A-satya-000000147d80 with rbridge id: 3318
discovered on LACP port 4/17
CLUSTER AUTOCONFIG INFO - New Client: A-satya-000000c74d40 with rbridge id: 2668
discovered on Static port 3/13
CLUSTER AUTOCONFIG INFO - Port 3/14 added as Static interface to
Client:A-satya-000000c74d40
LAG MCT-CCAC-LAG_1 deployed successfully!
Spanning tree is disabled on CCEP port 4/17 of MCT Client: A-satya-000000147d80.
CLUSTER AUTOCONFIG INFO - Port 4/17 is successfully programmed as client
interface. Removing from autoconfig port list.
debug clLAG MCT-CCAC-LAG_2 deployed successfully!
Spanning tree is disabled on CCEP port 3/13 of MCT Client: A-satya-000000c74d40.
CLUSTER AUTOCONFIG INFO - Port 3/13 is successfully programmed as client
interface. Removing from autoconfig port list.
CLUSTER AUTOCONFIG INFO - Port 3/14 is successfully programmed as client
interface. Removing from autoconfig port list.
CLUSTER AUTOCONFIG INFO - Cluster 1 client auto-config process stopped
debug cluster config
Syntax: [no] debug cluster config
This command enables debugging for any addition or deletion of the clusters, addition or deletion
of the clients, or exchange of cluster finite state machine (FSM) messages between the peer and
the client isolation mode.
If the debug cluster config command is enabled, the output similar to the following is displayed.
Brocade# debug cluster config
CLUSTER Config debugging is now ON
Brocade# config terminal
Brocade# cluster ABC 1
Brocade(config-cluster-ABC)# rbridge-id 200
Brocade(config-cluster-ABC)# session-vlan 100
Brocade(config-cluster-ABC)# icl icl1 ethernet 4/3