Brocade FastIron SX, FCX, and ICX Diagnostic Reference - Manual (Page 54)

42 Brocade FastIron SX, FCX, and ICX Diagnostic Reference
53-1003076-02
MCT show commands
3
R1 100 Deployed no 1/15 - Preforwarding
Remote
The command output resembles the following example for the speciifed client..
Brocade# show cluster 1 client c1
Cluster abc 1
=============
Rbridge Id: 101, Session Vlan: 3999, Keep-Alive Vlan: 4001
Cluster State: Deploy
Client Isolation Mode: Loose
Configured Member Vlan Range: 100 to 105
Active Member Vlan Range: 100 to 105
MCT Peer's Reachability status using Keep-Alive Vlan: Peer Reacheable
Client Info:
------------
Client: c1, rbridge-id: 300, Deployed
Client Port: 3/3
State: Up
Number of times Local CCEP down: 1
Number of times Remote CCEP down: 0
Number of times Remote Client undeployed: 0
Total CCRR packets sent: 11
Total CCRR packets received: 12
show cluster config
Syntax: show cluster config [cluster_id | cluster_name]
This command displays only the cluster configuration information as shown in the following
example.
Brocade# show cluster 1 config
cluster abc 1
rbridge-id 20
session-vlan 3999
keep-alive-vlan 4001
icl icl1 ethernet 3/1
peer 10.1.1.1 rbridge-id 100 icl icl1
deploy
client c1
rbridge-id 300
client-interface ethernet 3/3
deploy
client c2
rbridge-id 301
client-interface ethernet 3/13
deploy
show mac cluster
Syntax: show mac cluster cluster_ID | cluster_name [local | remote | client | vlan]
• cluster_id - Specifies the cluster ID.
• cluster_name - Specifies the cluster name.
• local - Displays MAC entries that are learned locally.
• remote - Displays MAC entries that are learned through the MDUP message from the peer.