Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 1112)

1104 Brocade Mobility RFS Controller CLI Reference Guide
53-1003098-01
19
client-identity
user-role commands
Associates a client-identity (device fingerprinting) based filter. The role is assigned to a wireless
client matching any of the defined client identities.
For more information on configuring client identity fingerprints, see client-identity .
Supported in the following platforms:
• Access Points — Brocade Mobility 650 Access Point, Brocade Mobility 6511 Access Point,
Brocade Mobility 1220 Access Point, Brocade Mobility 71XX Access Point, Brocade
Mobility 1240 Access Point
• Wireless Controllers — Brocade Mobility RFS4000, Brocade Mobility RFS6000, Brocade
Mobility RFS7000
• Service Platforms — Brocade Mobility RFS9510
Syntax:
client-identity <CLIENT-IDENTITY-NAME> {<CLIENT-IDENTITY-NAME>}
Parameters
client-identity <CLIENT-IDENTITY-NAME> {<CLIENT-IDENTITY-NAME>}
Usage Guidelines:
When associating a single or multiple client identities with a role policy, ensure that a client identity
group, containing all the client identities used by the role policy, is attached to the device or profile
using the role policy. In other words, group all the client identities (used in this role policy) in a client
identity group, and associate this group to the profile or device using this role policy.
For more information on configuring client identities and client identity groups, see client-identity ,
and client-identity-group .
For more information on associating a client identity group and a role policy to a profile or a device,
see
use .
Example
rfs4000-229D58(config-role-policy-test-user-role-test)#client-identity
TestClientIdentity
rfs4000-229D58(config-role-policy-test-user-role-test)#commit
rfs4000-229D58(config-role-policy-test-user-role-test)#client-identity
ClientIdentityWindows
rfs4000-229D58(config-role-policy-test-user-role-test)#
rfs4000-229D58(config-role-policy-test-user-role-test)#show context
user-role test precedence 1
client-identity TestClientIdentity
client-identity ClientIdentityWindows
rfs4000-229D58(config-role-policy-test-user-role-test)#
client-identity
<CLIENT-IDENTITY-NAME> Specifies the client-identity fingerprint to match (should be existing and configured)
•
<CLIENT-IDENTITY-NAME> – Specify the client identity signature name.
Multiple client identities can be configured with a role policy.