Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 201)

Brocade Mobility RFS Controller CLI Reference Guide 185
53-1003098-01
4
Example
rfs7000-37FABE(config-captive-portal-test)#data-limit 200 action
log-and-disconnect
rfs7000-37FABE(config-captive-portal-test)#
rfs7000-37FABE(config-captive-portal-test)#show context
captive-portal test
data-limit 200 action log-and-disconnect
rfs7000-37FABE(config-captive-portal-test)#
Related Commands:
inactivity-timeout
captive-portal-mode commands
Defines an inactivity timeout in seconds. If a frame is not received from a client for the specified
interval, the current session is terminated.
Supported in the following platforms:
• Access Points — Brocade Mobility 650 Access Point, Brocade Mobility 6511 Access Point,
Brocade Mobility 1220 Access Point, Brocade Mobility 71XX Access Point, Brocade
Mobility 1240 Access Point
• Wireless Controllers — Brocade Mobility RFS4000, Brocade Mobility RFS6000, Brocade
Mobility RFS7000
• Service Platforms — Brocade Mobility RFS9510
Syntax:
inactivity-timeout <300-86400>
Parameters
inactivity-timeout <300-86400>
Example
rfs7000-37FABE(config-captive-portal-test)#inactivity-timeout 750
rfs7000-37FABE(config-captive-portal-test)#show context
captive-portal test
access-type logging
access-time 35
custom-auth info bob,\ [email protected]
connection-mode https
inactivity-timeout 750
accounting syslog host 172.16.10.13 port 1
rfs7000-37FABE(config-captive-portal-test)#
Related Commands:
no Removes data limit enforcement for captive portal clients
<300-86400> Defines the timeout interval after which a captive portal session is automatically terminated
•
<300-86400> – Specify a value from 300 - 86400 seconds. The default is 10 minutes or 600 seconds.
no Removes the client inactivity interval configured with this captive portal