Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) User Manual

Page 554

Advertising
background image

Brocade Mobility RFS Controller CLI Reference Guide

541

53-1003098-01

7

file)

controller WLAN controller configuration

critical-resource Critical Resource

crypto Encryption related commands

device-upgrade Device firmware upgrade

dot1x 802.1X

dscp-mapping Configure IP DSCP to 802.1p

priority mapping for untagged

frames

email-notification Email notification configuration

enforce-version Check the firmware versions of

devices before interoperating

environmental-sensor Environmental Sensors Configuration

events System event messages

export Export a file

floor Set the floor within a area where

the system is located

gre GRE protocol

http-analyze Specify HTTP-Analysis configuration

interface Select an interface to configure

ip Internet Protocol (IP)

l2tpv3 L2tpv3 protocol

l3e-lite-table L3e lite Table

led Turn LEDs on/off on the device

led-timeout Configure the time for the led to

turn off after the last radio state

change

legacy-auto-downgrade Enable device firmware to auto

downgrade when other legacy devices

are detected

legacy-auto-update Auto upgrade of legacy devices

lldp Link Layer Discovery Protocol

load-balancing Configure load balancing parameter

logging Modify message logging facilities

mac-address-table MAC Address Table

mac-auth 802.1X

memory-profile Memory profile to be used on the

device

meshpoint-device Configure meshpoint device

parameters

meshpoint-monitor-interval Configure meshpoint monitoring

interval

min-misconfiguration-recovery-time Check controller connectivity after

configuration is received

mint MiNT protocol

misconfiguration-recovery-time Check controller connectivity after

configuration is received

neighbor-inactivity-timeout Configure neighbor inactivity

timeout

neighbor-info-interval Configure neighbor information

exchange interval

no Negate a command or set its

defaults

noc Configure the noc related setting

ntp Ntp server A.B.C.D

power-config Configure power mode

preferred-controller-group Controller group this system will

prefer for adoption

preferred-tunnel-controller Tunnel Controller Name this system

will prefer for tunneling extended

Advertising