Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 1289)

Brocade Mobility RFS Controller CLI Reference Guide 1281
53-1003098-01
27
Related Commands:
shutdown
meshpoint-config-instance
Shuts down this meshpoint. Use this command to prevent an AP from participating in a mesh
network.
Supported in the following platforms:
• Access Points — Brocade Mobility 1220 Access Point, Brocade Mobility 71XX Access Point,
Brocade Mobility 1240 Access Point
• Access Points (as root APs only) — Brocade Mobility 650 Access Point
• Wireless Controllers — Brocade Mobility RFS6000, Brocade Mobility RFS7000
• Service Platforms — Brocade Mobility RFS9510
Syntax:
shutdown
Parameters
None
Example
rfs7000-37FABE(config-meshpoint-test)#shutdown
rfs7000-37FABE(config)
Related Commands:
use
meshpoint-config-instance
Uses a Quality of Service (QoS) policy defined specifically for meshpoints. To use this QoS policy, it
must be defined. To define a meshpoint QoS policy, see
meshpoint-qos-policy-config-instance .
Supported in the following platforms:
• Access Points — Brocade Mobility 1220 Access Point, Brocade Mobility 71XX Access Point,
Brocade Mobility 1240 Access Point
• Access Points (as root APs only) — Brocade Mobility 650 Access Point
• Wireless Controllers — Brocade Mobility RFS6000, Brocade Mobility RFS7000
• Service Platforms — Brocade Mobility RFS9510
Syntax:
use meshpoint-qos-policy <MESHPOINT-QOS-POLICY-NAME>
no Resets the restriction that only 802.11n capable neighbor devices can associate with this meshpoint
service Invokes service commands to troubleshoot or debug
no Enables an AP as a meshpoint