Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) User Manual
Page 406
Brocade Mobility RFS Controller CLI Reference Guide
391
53-1003098-01
5
: service advanced-wips clear-event-history
(dos-eap-failure-spoof|id-theft-out-of-sequence|id-theft-eapol-success-spoof-
detected|wlan-jack-attack-detected|essid-jack-attack-detected|monkey-jack-att
ack-detected|null-probe-response-detected|fata-jack-detected|fake-dhcp-server
-detected|crackable-wep-iv-used|windows-zero-config-memory-leak|multicast-all
-systems-on-subnet|multicast-all-routers-on-subnet|multicast-ospf-all-routers
-detection|multicast-ospf-designated-routers-detection|multicast-rip2-routers
-detection|multicast-igmp-routers-detection|multicast-vrrp-agent|multicast-hs
rp-agent|multicast-dhcp-server-relay-agent|multicast-igmp-detection|netbios-d
etection|stp-detection|ipx-detection|invalid-management-frame|invalid-channel
-advertized|dos-deauthentication-detection|dos-disassociation-detection|dos-r
ts-flood|rogue-br-detection|accidental-association|probe-response-flood|dos-c
ts-flood|dos-eapol-logoff-storm|unauthorized-bridge)
: service start-shell
: service pktcap on(bridge|drop|deny|router|wireless|vpn|radio
(all|<1-3>) (|promiscuous)|rim|interface `WORD|ge <1-4>|me1|pc <1-4>|vlan
<1-4094>')(|{direction (any|inbound|outbound)|acl-name WORD|verbose|hex|count
<1-1000000>|snap <1-2048>|write (FILE|URL|tzsp WORD)|tcpdump})(|filter LINE)
Mode : Profile Mode
Command : service watchdog
Mode : Radio Mode
Command : service antenna-type
(default|dual-band|omni|yagi|embedded|panel|patch|sector|out-omni|in-patch|AP
650-int)
: service disable-erp
: service disable-ht-protection
: service recalibration-interval <0-65535>
..........................................................................
rfs7000-37FABE>
rfs7000-37FABE>help search mint only-show
Found 8 references for "mint"
Mode : User Exec
Command : show mint neighbors (|details)(|(on DEVICE-NAME))
: show mint links (|details)(|(on DEVICE-NAME))
: show mint id(|(on DEVICE-NAME))
: show mint stats(|(on DEVICE-NAME))
: show mint route(|(on DEVICE-NAME))
: show mint lsp
: show mint lsp-db (|details)(|(on DEVICE-NAME))
: show mint mlcp(|(on DEVICE-NAME))
rfs7000-37FABE>
no
Negates a command or sets its default. Though the
no
command is common to the User Exec, Priv
Exec, and Global Config modes, it negates a different set of commands in each mode.
Supported in the following platforms:s
•
Access Points — Brocade Mobility 650 Access Point, Brocade Mobility 6511 Access Point,
Brocade Mobility 1220 Access Point, Brocade Mobility 71XX Access Point, Brocade
Mobility 1240 Access Point