Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 327)

Brocade Mobility RFS Controller CLI Reference Guide 311
53-1003098-01
4
• Access Points — Brocade Mobility 650 Access Point, Brocade Mobility 6511 Access Point,
Brocade Mobility 1220 Access Point, Brocade Mobility 71XX Access Point, Brocade
Mobility 1240 Access Point
• Wireless Controllers — Brocade Mobility RFS4000, Brocade Mobility RFS6000, Brocade
Mobility RFS7000
• Service Platforms — Brocade Mobility RFS9510
Syntax:
role-policy <ROLE-POLICY-NAME>
Parameters
role-policy <ROLE-POLICY-NAME>
Example
rfs7000-37FABE(config)#role-policy role1
rfs7000-37FABE(config-role-policy-role1)#?
Role Policy Mode commands:
default-role Configuration for Wireless Clients not matching any role
ldap-deadperiod Ldap dead period interval
ldap-server Add a ldap server
ldap-service Enable ldap attributes in role definition
ldap-timeout Ldap query timeout interval
no Negate a command or set its defaults
user-role Create a role
clrscr Clears the display screen
commit Commit all changes made in this session
do Run commands from Exec mode
end End current mode and change to EXEC mode
exit End current mode and down to previous mode
help Description of the interactive help system
revert Revert changes
service Service Commands
show Show running system information
write Write running configuration to memory or terminal
rfs7000-37FABE(config-role-policy-role1)#
NOTE
For more information on role policy commands, see Chapter 19, ROLE-POLICY .
Related Commands:
routing-policy
Global Configuration Commands
Configures a routing policy
Supported in the following platforms:
<ROLE-POLICY-NAME> Specify the role policy name. If the policy does not exist, it is created.
no Removes an existing role policy