Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 1304)

1296 Brocade Mobility RFS Controller CLI Reference Guide
53-1003098-01
27
rfs4000-229D58(config-profile-testAP71XX-meshpoint-test)#
rfs4000-229D58(config-profile-testAP71XX-meshpoint-test)#acs ocs-frequency
2.4GHz 1
rfs4000-229D58(config-profile-testAP71XX-meshpoint-test)#
rfs4000-229D58(config-profile-testAP71XX-meshpoint-test)#show context
meshpoint-device test
acs ocs-frequency 2.4GHz 1
acs osc-duration 2.4GHz 30
acs channel-hold-time 2.4GHz 2500
rfs4000-229D58(config-profile-testAP71XX-meshpoint-test)#
Related Commands:
exclude
meshpoint-device-commands
Enables wired-peer (that are wired MiNT level-1 neighbors) exclusion
Supported in the following platforms:
• Access Points — Brocade Mobility 1220 Access Point, Brocade Mobility 71XX Access Point,
Brocade Mobility 1240 Access Point
• Access Points (as root APs only) — Brocade Mobility 650 Access Point
Syntax:
exclude wired-peer mint-level-1
Parameters
exclude wired-peer mint-level-1
Example
rfs4000-229D58(config-profile-testAP71XX-meshpoint-test)#exclude wired-peer
mint-level-1
rfs4000-229D58(config-profile-testAP71XX-meshpoint-test)#
rfs4000-229D58(config-profile-testAP71XX-meshpoint-test)#show context
meshpoint-device test
exclude wired-peer mint-level-1
rfs4000-229D58(config-profile-testAP71XX-meshpoint-test)#
Related Commands:
no Reverts the configured ACS settings to default
exclude wired-peer Excludes neighboring mesh devices
wired-peer mint-level-1 Excludes neighboring wired mesh devices with MiNTlevel-1 link
When enabled, all neighboring wired mesh devices are excluded from mesh links.
no Disables wired-peer exclusion on this meshpoint