Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 715)

702 Brocade Mobility RFS Controller CLI Reference Guide
53-1003098-01
7
dynamic-chain-selection
interface-config-radio-instance
Enables automatic antenna mode selection (single antenna for non-11n transmit rates). This
option is enabled by default.
Supported in the following platforms:
• Access Points — Brocade Mobility 650 Access Point, Brocade Mobility 6511 Access Point,
Brocade Mobility 1220 Access Point, Brocade Mobility 71XX Access Point, Brocade
Mobility 1240 Access Point
Syntax:
dynamic-chain-selection
Parameters
None
Example
rfs7000-37FABE(config-profile-71xxTestProfile-if-radio1)#dynamic-chain-select
ion
rfs7000-37FABE(config-profile-71xxTestProfile-if-radio1)#
Related Commands:
ekahau
interface-config-radio-instance
Enables Ekahau multicast packet forwarding
Supported in the following platforms:
• Access Points — Brocade Mobility 650 Access Point, Brocade Mobility 6511 Access Point,
Brocade Mobility 1220 Access Point, Brocade Mobility 71XX Access Point, Brocade
Mobility 1240 Access Point
Syntax:
ekahau [forward|mac <MAC>]
ekahau forward ip <IP> port <0-65535>
Parameters
ekahau [forward|mac <MAC>]
no Uses the configured transmit antenna mode for all clients
forward ip <IP>
port <0-65535> Enables multicast packet forwarding to the Ekahau engine
•
ip <IP> – Configures the IP address of the Ekahau engine in the A.B.C.D format
•
port <0-65535> – Specifies the TaZman Sniffer Protocol (TZSP) port on Ekahau engine from
0 - 65535
TZSP is an encapsulation protocol, which is generally used to wrap 802.11 wireless packets.
mac <MAC> Configures the multicast MAC address to forward the packets
•
<MAC> – Specify the MAC address in the AA-BB-CC-DD-EE-FF format.