Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 425)

410 Brocade Mobility RFS Controller CLI Reference Guide
53-1003098-01
5
service wireless client quiet-element [start|stop]
service wireless client trigger-bss-transition <MAC> url <URL> {on
<DEVICE-OR-DOMAIN-NAME>}
service wireless dump-core-snapshot
service wireless meshpoint zl <MESHPOINT-NAME> [on <DEVICE-NAME>] {<ARGS>}
mode
[active|passive|table] Specifies the beacon measurement mode. The following modes are available:
•
Active – Requests beacon measurements in the active mode
•
Passive – Requests beacon measurements in the passive mode
•
Table – Requests beacon measurements in the table mode
ssid [<SSID>|any] Specifies if the measurements have to be made for a specified SSID or for any SSID
•
<SSID> – Requests beacon measurement for a specified SSID
•
any – Requests beacon measurement for any SSID
channel-report
[<CHANNEL-LIST>|
none] Configures channel report in the request. The request can include a list of channels or can apply to all
channels.
•
<CHANNEL-LIST> – Request includes a list of channels. The client has to send beacon measurements
only for those channels included in the request
•
none – Request applies to all channels
on <DEVICE-NAME> Optional. Sends requests on a specified device
•
<DEVICE-NAME> – Specify the name of the AP, wireless controller, or service platform.
wireless client
quiet-element Enables/disables the quite-element information in beacons sent to wireless clients
start Enables the quite-element information in beacons sent to wireless clients. This is the interval for which all
wireless clients are to remain quiet.
stop Disables the quite-element information in beacons sent to wireless clients. Once disabled, this information
is no longer included in beacons.
wireless client
trigger-bss-transition Sends a 80211v-Wireless Network Management BSS transition request to a client
<MAC> Specifies the wireless client’s MAC address
url <URL> Specifies session termination URL
on
<DEVICE-OR-DOMAIN-NAME
> Optional. Sends request on a specified device
•
<DEVICE-OR_DOMAIN-NAME> – Specify the name of the AP, wireless controller, service platform, or
RF Domain.
wireless client
dump-core-snapshot Triggers a debug core-dump of the wireless module
service wireless meshpoint Runs zonal level commands for a meshpoint
zl Runs zonal commands
<MESHPOINT-NAME> Runs zonal commands for the meshpoint identified by the <MESHPOINT-NAME> keyword
on <DEVICE-NAME> Runs zonal commands for the specified meshpoint on a specified AP, wireless controller, or service
platform
<ARGS> Optional. Specifies the zonal arguments