Brocade Mobility RFS Controller CLI Reference Guide (Supporting software release 5.5.0.0 and later) - Manual (Page 741)

728 Brocade Mobility RFS Controller CLI Reference Guide
53-1003098-01
7
• Access Points — Brocade Mobility 650 Access Point, Brocade Mobility 6511 Access Point,
Brocade Mobility 1220 Access Point, Brocade Mobility 71XX Access Point, Brocade
Mobility 1240 Access Point
Syntax:
sniffer-redirect [omnipeek|tzsp] <IP> channel [1|10|100|100w --------]
{snap <1-65535> (append descriptor)}
Parameters
sniffer-redirect [omnipeek|tzsp] <IP> channel [1|10|100|100w ---------]
{snap <1-65535> (append descriptor)}
Example
rfs7000-37FABE(config-profile-71xxTestProfile-if-radio1)#sniffer-redirect
omnipeek 172.16.10.1 channel 1
rfs7000-37FABE(config-profile-71xxTestProfile-if-radio1)#show context
interface radio1
rf-mode sensor
placement outdoor
mesh client
rts-threshold 100
off-channel-scan channel-list 2.4GHz 1
guard-interval long
aggregation ampdu tx-only
rifs tx-only
sniffer-redirect omnipeek 172.16.10.1 channel 1
aeroscout forward
ekahau forward ip 172.16.10.1 port 3
non-unicast tx-rate bss 1 dynamic-all
non-unicast tx-rate bss 2 highest-basic
non-unicast tx-rate bss 3 highest-basic
non-unicast tx-rate bss 4 highest-basic
non-unicast tx-rate bss 5 highest-basic
non-unicast tx-rate bss 6 highest-basic
--More--
sniffer-redirect Captures and redirects packets to an IP address running a packet capture/analysis tool
omnipeek Encapsulates captured packets in proprietary header (use with OmniPeek and plug-in)
tzsp Encapsulates captured packets in TZSP (used with WireShark and other tools)
<IP> Specify the IP address of the device running the capture/analysis tool (the host to which captured off
channel scan packets are redirected)
[1|10|100|100w ----------] Specify the channel to capture packets
•
1 – Channel 1 in 20 MHz mode (default setting)
•
10 – Channel 10 in 20 MHz mode
•
100 – Channel 100 in 20 MHz mode
•
100w – Channels 100w in 40 MHz mode (channels 100*,104)
snap <1-65535> Optional – Allows truncating of large captured frames at a specified length (in bytes). This option is
useful when capturing traffic with large frames. Use this option when only headers are needed for
analysis, since it reduces the bandwidth needed for sniffing, and (for typical values) eliminates any
fragmentation of the outer packet.
•
<1-65535> – Specify the maximum truncated byte length of captured packets
append descriptor Optional – Enables appending of the radio's receive descriptor to the captured packet