LumaSense Technologies INNOVA 1316A-3 - Manual (Page 10)

Chapter 1
_________________________________________________________________________________________
_____________________________________________________________________________
BE6024-12 1316A-3 Multi Gas Monitor LumaSense Technologies A/S
Instruction Manual Page 10 of 96
1.2.3 Power Supply
The power supply included in the 1316A-3 can be directly connected
to a wide range of single phase mains supplies and still be able to
produce the stable voltages required to keep the monitor within
calibration.
1.3 Software Description
The BZ6014 software is menu driven specifically written to control
the 1316A-3 monitor. The software allows you to change the
operational parameters and see the results of measurements on the
PC screen.
The software can be used to control up to four Multi Gas Monitors
1316A-3 including these instruments in your system allows up to 4
different sample points to be controlled measured by the BZ6014.
You can also use the PC’s filing system to save a series of
measurements for later recall any other PC software that can
interpret a space delimited file, for example certain spread sheet
programs.
Note though that the save-to-disk process is not a dump of data from
the 1316A-3 to the PC, but a process in which the data log file on the
PC is updated continuously.
Therefore, to use the PC to log data, it must be constantly attached
to the 1316A-3.
As well as providing control over the measurement configuration of
the monitor, the software also has calibration procedures that allow
you to calibrate the monitor against known reference gas
concentrations.
1.3.1 NDIR Module and the optional UA1372 Module Versions
LumaSense offers several NDIR modules giving the possibility to
configure the Multi Gas Monitor 1316A-3 for different applications.
Please contact your local LumaSense A/S representative for further
information.
LumaSense Electrochemical Sensors to be mounted in the Manifold of
the UA1372. Beside Oxygen (VM0200 A) it is possible to install a, NO
(VM0201A) sensor. Please contact your local LumaSense A/S
representative for further information.
The NDIR Module and the Electrochemical Sensors are to be specified
prior to purchase.