3 checking the pump, Section 5.1.3 – LumaSense Technologies INNOVA 1316A-3 User Manual
Page 89
Advertising
Chapter 5
_________________________________________________________________________________________
_____________________________________________________________________________
BE6024-12
1316A-3 Multi Gas Monitor
LumaSense Technologies A/S
Instruction Manual
Page 89 of 96
3. Remove the fuses from the holders and check that they have
the correct rating (T 1.6 A slow-blow), see
4. If the installed fuses do not have the correct rating or are
faulty, install the correct fuses.
5. Screw the fuse holders into the monitor.
6. Attach the mains cable.
5.1.3 Checking the Pump
Pull down the Bench Commands menu.
Select Pump On/Off
Following window will appear.
Advertising