LumaSense Technologies INNOVA 1316A-3 - Manual (Page 31)

Chapter 2
_________________________________________________________________________________________
_____________________________________________________________________________
BE6024-12 1316A-3 Multi Gas Monitor LumaSense Technologies A/S
Instruction Manual Page 31 of 96
2.6.4 Workspace
The workspace is the main area of a screen on which information and
parameter values are printed.
2.6.5 Settings
Located below the workspace area.
Used to select the settings for the measurement task to perform.
Soft Keys to Start and Stop a measurement task and to Start a Zero
calibration are also located in the Settings area.
2.6.6 Active Benches
Located in the bottom part of the Main screen.
Show the COM ports used for up to four Type 1316A-3 attached to
the BZ6014.
2.6.7 Moving around the Screen
The BZ 6014 is menu-driven software. You move around the screen
to highlight the parameter or option fields you want to work with.
The <Tab> key will move the cursor to the next field.
<Shift> <Tab> will move you to the previous field.
2.6.8 Entering Values
Enter numeric values via the keyboard.
If you enter a value that is out of the expected range, there will be
an error window and you must enter a value within range.
Pressing on <ok> returns you to the Main Menu and writes any
changes you have made either to the configuration file or to the
1316A-3 monitor, whichever is appropriate.
2.7 Selecting the Correct Serial Port
Before using the monitor, it must be ensured that the BZ 6014
software is set to use the same serial port (COM port) as that
physically used. Please refer to section 2.3 to select the correct port
for your 1316A-3 monitor. To set the correct port, do the following
procedure: