LumaSense Technologies INNOVA 1316A-3 - Manual (Page 34)

Chapter 3
_________________________________________________________________________________________
_____________________________________________________________________________
BE6024-12 1316A-3 Multi Gas Monitor LumaSense Technologies A/S
Instruction Manual Page 34 of 96
3.1 General Information
This chapter guides you through the configuration options available
on the Main Menu. You should configure both the software (the BZ
6014 program) and the hardware (the 1316A-3 monitor(s) installed)
to suit your local requirements before calibrations and measurements
are made.
It is assumed that your 1316A-3 monitor and computer have been
installed correctly and you are familiar with using the software. For
instructions on installation and using the software see Chapter 2 .
Note: the calibration procedure is covered in Chapter 4 .
3.2 Software Configuration
3.2.1 BZ 6014 Main Menu
From the main Menu (see figure 3.1 ) select the appropriate settings
for the monitoring task.
If the COM ports are set up correctly it is possible to select just to
press the Start Soft key and the measured data will be displayed.
3.2.2 Description of the Settings in the Main Menu Screen.
Time stamp:
Activating the Time Stamp gives a read out of measurement data
with the PC’s time stamp.
Relative Time:
Using the relative Time the data is presented on a time axis in
seconds from the time when measurement was started.
Gas Conc:
Selecting this gives a read out of Gas concentrations. see figure 3.1 .