LumaSense Technologies INNOVA 1316A-3 - Manual (Page 46)

Chapter 3
_________________________________________________________________________________________
_____________________________________________________________________________
BE6024-12 1316A-3 Multi Gas Monitor LumaSense Technologies A/S
Instruction Manual Page 46 of 96
Figure 3.10. The BZ 6014’s status Screen
The BZ 6014 and 1316A-3 have built-in test procedures that are able
to monitor various electronic and mechanical parts – for example,
the flow rate. If anything abnormal is detected with any of the
parameters tested for, the error will be reported in the status screen
see figure 3.10.
The status screen in figure 3.10 shows that zero calibration is
required.
The System status and Data Status messages are described in this
manual when relevant for the task performed in a given section.
The problem status messages are described in section 3.4 below.
3.4 Screen Problem Status
In the bottom part of the Status screen, see figure 3.10, error and
warnings are displayed. If a fault status is discovered the text box text is
changed from OK to Check .