Fire-Lite MS-25E Addressable Fire Control Panel User Manual
Fire-Lite Equipment
Advertising
This manual is related to the following products:
Table of contents
Document Outline
- Contents
- Section 1 Introduction
- Section 2 Agency Listings, Approvals, and Requirements
- Section 3 Before You Begin Installing
- Section 4 Control Panel Installation
- 4.1 Mounting the Control Panel Cabinet
- 4.2 AC Power Connection
- 4.3 Battery Connection
- 4.4 SBUS Wiring
- 4.5 ANN-80 Remote Annunciator Installation
- 4.6 Model ANN-80 Connection to the Panel
- 4.7 Configuring Module
- 4.8 Telephone Connection
- 4.9 Notification Appliance/Auxiliary Power Circuits
- 4.10 On-Board Relays (Conventional, Power Limited)
- 4.11 Remote Station Applications
- Section 5 SLC Device Installation
- Section 6 Programming
- 6.1 UL 864 Programming Requirements
- 6.2 Control Panel Programming
- 6.3 Default Control Panel Configuration.
- 6.4 JumpStart Auto Programming
- 6.5 Modifying Panel Programming using a PC
- 6.6 Panel Programming Options
- 6.6.1 System Options
- 6.6.1.1 Synchronized Strobes Active When Horns Silenced
- 6.6.1.2 Silence/Reset Inhibit Enabled
- 6.6.1.3 Water Flow Delay
- 6.6.1.4 Installer Code (User ID)
- 6.6.1.5 Alarm Verification Time
- 6.6.1.6 Auto Test
- 6.6.1.7 Low AC Report Delay
- 6.6.1.8 Walk Test Reporting
- 6.6.1.9 Walk Test duration
- 6.6.1.10 Walk Test NAC Time out
- 6.6.1.11 Clock Source
- 6.6.1.12 Auto Daylight Savings Time
- 6.6.1.13 Remote Annunciator
- 6.6.2 Zone Programming
- 6.6.3 Output Point Programming
- 6.6.4 Notification Appliance Circuit (NAC) Programming
- 6.6.5 Relay Programming Options
- 6.6.6 Dialer Phone Line Programming Options
- 6.6.7 Dialer Account programming Options
- 6.6.1 System Options
- Section 7 System Operation
- 7.1 System Reset
- 7.2 Lamp Test
- 7.3 System Silence
- 7.4 Acknowledge
- 7.5 Viewing Active Alarm Points
- 7.6 Viewing Active Supervisory Points
- 7.7 Viewing Active Trouble Points
- 7.8 Walk Test
- 7.9 Fire Drill
- 7.10 Zone Disable Feature
- 7.11 Disabling Notification Circuits
- 7.12 Loss of AC power
- 7.13 Remote Connection Feature (ULC Installations Only)
- 7.14 Low Battery
- 7.15 Ground Fault
- 7.16 Phone Line Monitoring
- 7.17 Reporting Account Monitoring
- 7.18 SLC Fault
- 7.19 Dialer Error
- 7.20 Annunciator Description
- 7.21 Basic Operation
- 7.22 Operation Mode Behavior
- Section 8 Reporting
- Section 9 Trouble Shooting and Quick Tips
- Appendix A Compatible Devices
- Manufacturer Warranties and Limitation of Liability
- Model MS-25/MS-25C/MS-25E Basic Operating Instructions