Fire-Lite MS-25E Addressable Fire Control Panel - Manual (Page 41)

Control Panel Installation
53688 4-11
4.5.1 Mounting the ANN-80
This section of the manual describes mounting the remote annunciator. Figure 4-7 shows the
parts of the annunciator.
Figure 4-7 ANN-80 Annunciator Parts
The ANN-80 Series plastic enclosures can be surface or semi-flush mounted in a single,
double or 4” square electrical box.
To mount the ANN-80 Series enclosure:
1. Open the ANN-80 Series cover by turning the key switch counterclockwise to the ON
(Unlocked) position.
2. Push in the snap latch tab located on the right side while pulling the cover open.
3. Pull wire through 7/8” hole in backplate and feed through wire channel to lower left cor-
ner of backplate before routing to terminal block.
4. The cover must remain attached to the backplate while mounting the annunciator to the
electrical box/ wall. The cover cannot be reattached or removed after the annunciator has
been mounted.
5. Surface or Semi-flush mount the ANN-80 to a single, double or 4" square electrical box.
The ANN-SB80KIT(-R/-B/-W) is an available kit that contains two plastic backboxes that
can be used to surface mount the ANN-80.
Back Box
Inside Cover
LCD Display