Fire-Lite MS-25E Addressable Fire Control Panel - Manual (Page 57)

SLC Device Installation
53688 5-5
5.4 Wiring SLC Detectors
This section describes how to install heat and smoke detectors. All detectors ship with
installation instructions. Refer to the detector’s installation instructions for more detailed
information.
This information applies to the following models:
• HFS-P, HFS-PA, SD355 Photoelectric Smoke Detector
• HFS-PT, HFS-PTA, SD355T Photoelectric Smoke Detector with Thermal
• HFS-D, HFS-DA, D350PL Photoelectric Duct Detector
• HFS-T, HFS-TA, H355 Fixed Temperature Detector
To wire detectors:
1. Wire device bases as shown in Figure 5-3.
2. Set the address for each device as described in Section 5.5.
Figure 5-3 Heat and Smoke Detector Connection to the Panel.
Supervised
Power limited