KYORITSU 6050 - Manual (Page 28)

̶ 26 ̶
(5) Decide it with ENTER SWITCH("ENT" SWITCH).
Data will be stored and back to voltage measurement mode
automatically.
● By pressing MEMORY MODE EXIT SWITCH ("EXIT" SWITCH)
during an operation, can undo the last action.
● When making a measurement, press MEMORY MODE EXIT
SWITCH("EXIT" SWITCH) and release the MEMORY MODE.
Measurement cannot be performed when Test button is pressed
while " MEM " mark is being displayed on the LCD.
9.2 Recall the stored data
Stored data can be displayed on LCD according to following sequence.
(1) Press MEMORY MODE SWITCH ("MEM MODE" SWITCH) on
stand-by(at "Lo V" is displayed).
Then instrument becomes MEMORY MODE, and " MEM " mark
appears on the LCD. The action of each switch changes as shown
under each switch.
(2) Press MEMORY RECALL SWITCH ("RCL" SWITCH).
(3) Select the Data you want to recall with MEMORY SELECT SWITCH
("MEM ▼▲ "SWITCH).
(4) Decide it with ENTER SWITCH ("ENT" SWITCH).
Selected data can be called up.
(5) By pressing MEMORY SELECT SWITCH ("MEM ▼▲ "SWITCH),
indication is changed as follows.
Measured result Measurement Function PLACE No.
● By pressing MEMORY MODE EXIT SWITCH ("EXIT" SWITCH)
during an operation, can undo the last action.
● When making a measurement, press MEMORY MODE EXIT
SWITCH("EXIT" SWITCH) and release the MEMORY MODE.
Measurement cannot be performed when Test button is pressed
while " MEM " mark is being displayed on the LCD.
▲ ▲ ▼ ▼ ▼ ▲