Badger Meter ORION Classic (CE) - Manual (Page 24)

RTR Extended Status
Figure 26: Extended Status- RTR
The status indicators described below apply for an ORION Migratable (or Fixed Network in mobile mode) endpoint when
connected to an RTR
Status Indicator Description
Mobile Mode Endpoint is communicating in mobile transmission mode
IR Programmed Endpoint has been reprogrammed via IR
Low Battery Endpoint is reporting a low battery condition
Tamper Endpoint is reporting a tamper condition This condition occurs when the wire between the register
and the endpoint is cut or shorted, or the RTR is not connected See "" on page 19 for instructions
on clearing the tamper
No Usage Endpoint is reporting a no usage condition This condition occurs when there is no water flow
registered over a 30-day time frame
Leak Endpoint is reporting a potential leak condition when there is continuous usage over a 24-hour time
period without a 1-hour period of non-usage
Encoder Information Description
Size & Type The size and type of the meter for which the RTR was programmed Tap the button to change the
size and type See "IR Programming Meter Size, Type and Units of Measure (RTR, AdE)" on page 28 for
more information
Units The units of measure as defined by the RTR: cubic meters, cubic feet, gallons, imperial gallons or
liters Tap the button to change the units See "IR Programming Meter Size, Type and Units of Measure
(RTR, AdE)" on page 28 for more information
NOTE: N Refer to the ORION Migratable Endpoint product data sheet, available at www.badgermeter.com , for
complete information
ORION IR PROgRAMMINg
Page 24 April 2014 ORION® Endpoint Utility for Trimble® Ranger 3