Badger Meter ORION Classic (CE) - Manual (Page 39)

7 Align the optical head of the IR cable with the gas
endpoint IR LED port Then tap Program
Result: The gas endpoint is programmed.
Figure 57: Endpoint programmed
Possible Drive Circles
The Drive Circle? button provides access to a list of possible
drive circles
After performing an initial read of the endpoint, tap the Drive
Circle? button to see the list as shown in Figure 58 This is a
read only screen to help select the correct drive circle
Tap the Cancel button to return to the IR Programming screen
Figure 58: gas drive circles
ORION IR PROgRAMMINg
Page 39 April 2014 ORION® Endpoint Utility for Trimble® Ranger 3